Mouse test
Mouse wheel test
Scroll inside the box. Each notch is counted and drawn, and a wheel that jumps back the wrong way while you scroll shows up in red.
Scroll here, slowly then fast
- Up
- 0
- Down
- 0
- Wrong way
- 0
- Left / right
- 0 / 0
- Wheel clicks
- 0
- Last step
- –
How to test a scroll wheel
- Scroll slowly down ten notches inside the box, then up ten. On most wheels each notch you feel adds one step, and every step should land on the same side of the line.
- Scroll fast in one direction. A worn wheel often behaves at slow speed and skips when spun quickly. Any step that went the wrong way in the middle of a run turns red and is counted.
- Click the wheel to test the middle button, and tilt it left and right if your mouse has a tilting wheel. On a mouse without tilt, holding Shift while you scroll sends left and right steps in most browsers.
The page doesn't scroll while the pointer is inside the box, so you can spin the wheel freely. Copy results puts the counts on the clipboard for a warranty claim.
Advertisement
Why a wheel scrolls the wrong way
Most scroll wheels turn a small rotary encoder: two sets of contacts that open and close slightly out of step, so the mouse can tell which way the wheel is turning from which one changes first. When dust, hair or wear gets into the encoder, a contact chatters and the mouse briefly reads the turn backwards. The result is the familiar jump: you scroll down a page and it twitches up a line. Optical encoders, which read slots with light, suffer much less from it.
The test counts a step as wrong when it is sandwiched between two steps the other way, each within 200 milliseconds. Turning a wheel back and forth on purpose is slower than that, so a red bar almost always comes from the encoder.
Fixing a jumpy scroll wheel
- Blow compressed air into the gaps around the wheel while turning it, and spin it hard both ways a few dozen times; that alone often clears the contacts.
- Try another USB port, a fresh battery and, for a wireless mouse, a receiver closer to the mouse, since dropouts can look like skips.
- Check the maker's software for a firmware update, and turn off any smooth-scrolling or acceleration option while you test.
- If the skips persist, the encoder is worn: a warranty claim, or a replacement encoder for those happy to open the mouse.
Advertisement
Notches, lines and pixels
Last step shows what the browser received for the most recent step and its unit. Chrome and Edge on Windows usually report about 100 pixels per notch; Firefox may report lines or pixels; on a Mac, scrolling is accelerated, so faster turns send bigger or more frequent steps. A touchpad or a free-spinning wheel sends many small steps rather than one per notch, so for this test a notched wheel gives the clearest reading.
How far one notch scrolls a page is a system setting. In Windows it is under Settings, Bluetooth and devices, Mouse, where the default is three lines at a time; on a Mac, scrolling speed is under System Settings, Mouse.
Other mouse tests
The mouse click test checks every button and catches unwanted double clicks, the mouse DPI test measures how many counts the sensor reports per inch, and the polling rate test shows how often the mouse reports its position. Nothing you do here is recorded or sent anywhere.
Advertisement
Advertisement
Advertisement