Full-screen tool
Touch screen test
Draw with one finger or several, or sweep across a grid until every cell lights up. Areas that don't respond, and touches you didn't make, show up straight away.
C clearF full screenEsc close
What the test shows
- Dead zones. A line that breaks in the same place every time, or a grid cell that won't light however you touch it, marks an area where the screen doesn't register touch.
- Ghost touches. Lines or lit cells appearing where nothing touched the glass mean the screen is reporting touches on its own.
- Multi-touch. The control bar counts the touches down at once and the most it has seen. Put your fingers down one at a time to find how many your screen tracks.
- Pen pressure. On a device that reports stylus pressure, lines drawn with a pen get thicker as you press harder.
Advertisement
How to test a whole screen
Choose Fill a grid and sweep a finger slowly in rows from top to bottom, then do the same in columns. Go right to the edges and into the corners, where problems usually start. The control bar slides to the other side of the screen when your finger gets close, so no area is hidden behind it. When every cell has lit, the bar says all responded.
With Draw lines, draw slow straight lines across the screen from edge to edge, horizontally and then vertically. A smooth line means touch is tracked all the way along; a gap or a jump shows where it isn't.
How to fix a touch screen that isn't working
Start with the simple causes. Take off the case and any screen protector and test again, since a raised edge or a bubble can block touches near the frame. Clean and dry the screen, unplug the charger and restart the device, then repeat the test.
- Windows laptops and tablets: open Device Manager, expand Human Interface Devices, right-click HID-compliant touch screen and choose Disable device, then Enable device. If there is more than one entry, do the same for each (Microsoft's guide, Enable and disable a touchscreen in Windows).
- iPhone and iPad: Apple's guide, If the screen isn't working on your iPhone or iPad, suggests restarting, cleaning the screen, disconnecting accessories and removing any case or screen protector before contacting Apple.
If the same area still fails after all of that, the touch layer itself is likely at fault, which is a repair or warranty matter. To check the display rather than the touch layer, use the dead pixel test.
There is no press-and-hold exit here, because a finger held still is part of the test: tap Exit on the control bar, or press Esc on a keyboard. A mouse or trackpad works too, for trying the page on a computer.
Advertisement
Advertisement
Advertisement