Mouse test

Mouse DPI test

Move your mouse a distance you know and the page counts what the sensor reports, to give the real DPI. A bank card works as the ruler.

Press Start a run

Distance you will move the mouse
Measured DPI
–
eDPI
–
Input
–

Runs: none yet

How to measure your mouse's DPI

  1. Pick a distance you can mark. A bank card is 85.60 mm wide by the ISO/IEC 7810 standard every payment card follows, so it makes a ruler most people carry. A sheet of paper or a real ruler gives a longer run, which is more accurate.
  2. Line the mouse up with the left edge of the card, or a mark on the ruler, and note a point on the mouse to watch, such as its front edge.
  3. Press Start a run. The pointer disappears and the page takes over the mouse. Hold the left button, slide the mouse to the right until the same point reaches the far edge, and let go.
  4. Repeat three to five times. The page averages the runs. If you enter the DPI your mouse is set to, it says how far the measurement is from it.

Press Esc at any time to get the pointer back. Keep the mouse level: a run that drifts up or down by more than a tenth of its length is flagged.

Advertisement

What DPI means

DPI, dots per inch, and CPI, counts per inch, are the same figure: how many movement reports the sensor sends for each inch the mouse travels. At 800 DPI, moving one inch sends 800 counts; at 1,600, the same movement sends twice as many, so the pointer travels twice as far. A mouse's DPI setting is a promise, and sensors and firmware can read a few percent high or low. That matters most to players who use the same mouse settings across games or switch between mice.

eDPI multiplies DPI by a game's sensitivity setting, so players can compare their aim speed across different mice: 800 DPI at sensitivity 0.5 is an eDPI of 400, the same as 400 DPI at sensitivity 1.0.

Why the browser matters

Normally the system reshapes mouse movement before a program sees it: pointer speed scales it and acceleration makes fast moves travel further. In Chrome and Edge, the page asks for unadjusted movement, which gives the sensor's own counts on Windows, macOS and ChromeOS, and the Input reading says Raw. Firefox and Safari give adjusted movement only, so the figure depends on your pointer settings. On Windows with Enhance pointer precision off and the pointer speed on the middle notch (6 of 11), the pointer moves one screen pixel per count, and the page allows for display scaling, so the reading is still sound.

Advertisement

If the reading looks wrong

Other mouse tests

The polling rate test shows how many times a second the mouse reports, the mouse click test checks every button for double clicks, and the mouse wheel test catches a wheel that skips. Nothing you do here is recorded or sent anywhere.

Advertisement

Advertisement

Advertisement

Advertisement