Screen test

Monitor test

Step through eight test patterns to check a new or second-hand display while you can still return it.

→Space next← back18 jumpF full screenEsc close

Before you start

Let the display warm up for fifteen minutes, set your computer to the screen's native resolution and switch off picture modes such as dynamic contrast or eco mode, which change what the patterns show. For the sharpness check, set display scaling to 100% if you can.

Advertisement

The eight tests

1. Black level

Sixteen dark grey squares on black, numbered by how bright they are. On a well set up screen you can make out the squares from about 3 upward. If the first several blend into the background, raise the brightness or black level setting; if the black itself looks grey, lower it.

2. White level

The same idea at the bright end: light grey squares on white. If the squares near 254 vanish, the contrast is set too high and bright detail is being clipped.

3. Gradients

Grey, red, green and blue bands fade from black to full colour. Smooth bands mean good colour depth. Visible steps, stripes or a tint in the grey band point to banding or a colour cast.

4 and 5. Uniformity

A mid grey and a dark grey fill the screen. Look for darker corners, cloudy patches, a colour tint on one side or, on the dark grey in a dark room, light leaking in from the edges.

6. Sharpness

Fine vertical lines, horizontal lines and a checkerboard, each one pixel wide, with text from 9 to 20 pixels. From a distance each area should look like even grey. Blur, shimmering or moiré means the picture is being scaled.

7. Geometry

A grid of squares with a circle in the middle. The circle should be round and the squares square: if not, the screen is stretching the picture to the wrong shape.

8. Motion

Blocks slide across the screen. A long smear or a bright or dark outline behind them shows slow pixel response or overdrive artefacts, which matter most for games and sport.

For dead and stuck pixels, use the dead pixel test, which fills the screen with one solid colour at a time. To adjust the settings rather than check for faults, follow the monitor calibration steps. To check the refresh rate in hertz, use the refresh rate test; for light leaks on an LCD, the backlight bleed test; for ghosts on an OLED, the OLED burn-in test.

Advertisement

Advertisement

Advertisement

Advertisement