Screen test
TV test pattern
One test card with colour bars, greyscale steps, a geometry grid and circles, fine lines for focus, and frames that show whether the edges of the picture are cut off.
F full screenEsc close
Showing it on a TV or projector
Open this page in the TV's own web browser, or connect a laptop by HDMI and press Start with the browser window on the TV or projector. Set the computer to the display's native resolution, so each line in the card lands on a real pixel. The middle of the card shows the size it was drawn at: on a 4K TV running at its native resolution it reads 3840 × 2160, the ultra-high-definition size in ITU-R Recommendation BT.2020, and on a Full HD set 1920 × 1080.
Advertisement
Overscan: are the edges cut off?
The card has three frames: white at the very edge, yellow 2.5% in and red 5% in. If you can't see the white frame, the TV is cropping the picture and enlarging what's left, which softens fine detail and can hide the edges of a computer desktop or game menus. Look in the TV's picture size or aspect ratio settings for an option that shows the full picture or fits it to the screen; makers name it differently. When it's right, all three frames show and the 1-pixel lines look clean.
Geometry and focus for projectors
- Keystone: the grid's squares should be square and its lines parallel. If the image is a trapezium, move or tilt the projector, or use lens shift if it has one, before reaching for digital keystone correction, which resamples the picture and softens fine detail.
- Focus: focus on the 1-pixel line groups in the middle until the lines separate cleanly, then check the corner circles, since focus can differ across the picture.
- Aspect ratio: the big circle should be round. If it looks like an oval, the projector or source is set to the wrong aspect ratio.
Advertisement
Turning off overscan and picture processing
If the Edge frame is cut off, the TV is enlarging the picture. The setting that stops it has a different name on each brand: Just Scan on LG, Screen Fit or Fit to Screen on Samsung, and Full Pixel on Sony, usually under picture size or aspect ratio. While you are there, a mode such as Movie, Cinema or Filmmaker Mode turns off motion smoothing and over-sharpening, which is why the one-pixel lines can shimmer or show halos in the default mode.
Keystone or lens shift
If the grid on a projector is wider at the top than the bottom, the projector is tilted. Digital keystone correction squeezes the picture back into a rectangle but uses fewer of the projector's pixels, softening the one-pixel lines. Lens shift, where a projector has it, moves the picture optically without that loss, so level the projector and use lens shift first, and keystone only for what remains.
Advertisement
Colour and greyscale
The colour bars run white, yellow, cyan, green, magenta, red, blue and black. Each should be clean and distinct, with no bar bleeding into the next. Below them, 11 grey steps run from black to white: you should be able to tell every step from its neighbours. If the darkest steps merge, brightness or black level is too low; if the lightest merge, contrast is too high. The monitor calibration steps set both, and work on TVs as well.
The card is a still image, so it's safe to leave on screen while you adjust. Press F to toggle full screen and Esc to close. For dead pixels, the dead pixel test fills the screen with one colour at a time.
Advertisement
Advertisement
Advertisement